Csa Marking - ABB ACS880-37 Hardware Manual

•
For installation in the United States, branch circuit protection must be provided in
accordance with the National Electrical Code (NEC) and any applicable local codes.
To fulfill this requirement, use the UL classified fuses.
•
For installation in Canada, branch circuit protection must be provided in accordance
with the Canadian Electrical Code and any applicable provincial codes. To fulfill this
requirement, use the UL classified fuses.
•
The drive provides overload protection in accordance with the National Electrical Code
(NEC).

CSA marking

CSA marking is pending for the drive. The approval is valid with rated voltages.
"C-tick" marking
C-tick marking is pending for the drive.
"C-tick" marking is required in Australia and New Zealand. A "C-tick" mark is attached to
each drive in order to verify compliance with the relevant standard (IEC 61800-3:2004,
Adjustable speed electrical power drive systems – Part 3: EMC product standard including
specific test methods), mandated by the Trans-Tasman Electromagnetic Compatibility
Scheme.
For fulfilling the requirements of the standard, see section
3:2004.
EAC (Eurasian Conformity) marking
EAC marking is pending for the drive at the time of printing.
Tightening torques
Unless a tightening torque is specified in the text, the following torques can be used.
Electrical connections

Size
M3
M4
M5
M6
M8
M10
M12
M16
Mechanical connections

Size
M5
Torque
N·m
0.5
1
4
9
22
42
70
120
Max. torque
N·m
6
Technical data 189
Compliance with EN 61800-
Note
Strength class 4.6...8.8
Strength class 4.6...8.8
Strength class 8.8
Strength class 8.8
Strength class 8.8
Strength class 8.8
Strength class 8.8
Strength class 8.8
Note
Strength class 8.8