Analog Output Range; Analog Output Source; Response Of Analog Output To Faults Or Simatic Stop; Start Value For The Analog Output - Siemens SIWAREX WP241 Manual

Scale parameters and functions of the belt scale
8.9 DR 7 Process interfaces
8.9.6

Analog output range

This parameter is used to define the output current range.
Value
0
1
8.9.7

Analog output source

The analog output can be used for a range of purposes. This parameter defines the tag that
controls the analog output.
Value
0
1
2
3
4
8.9.8

Response of analog output to faults or SIMATIC STOP

This parameter defines the response of the analog output following a fault of the SIWAREX
module or SIMATIC STOP.
Value
0
1
2
3
8.9.9

Start value for the analog output

This parameter defines the specified value at which 0 or 4 mA is output. The value can be
greater or less than the end value.
102
Response
Switch off
Retain function
Output configured output value, e.g. 3.5 mA
Output maximum value (24 mA, NAMUR)
Output current
0 ... 20 mA
4 ... 20 mA
Basis for the analog output
Belt speed
Belt load
Material flow rate
External specification, DR 17
(Specified in mA)
Via SIMATIC S7 interface
Manual, 04/2014, A5E33713528A
SIWAREX WP241