Siemens SIWAREX WP241 Manual page 150

Command lists
10.2 Command lists
Command Command
code
85 Apply (nominal) speed
86 Apply speed parameters
"belt loaded"
87 Apply pulse parameter
88 Apply initial zero
calibration digits
89 Apply span calibration
digits
Table 10- 2 Commands 450 ... 499: Trace commands
Command Command
code
451 Trace ON
452 Trace OFF
453 Single trace element
454 Reset trace memory
Table 10- 3 Commands 700 ... 899: HMI display switchover (DR34 – ASCII display)
Command Command
code
701 Increased resolution
715 Display weight
735 Flow rate in %
740 Belt load
745 Belt load in %
760 Speed
765 Speed in %
771 Master totalizer S1
772 Main totalizer S2
773 Total S3
774 Total S4
775 Total S5
776 Total S6
801 Display calibration
regulations
150
Description
The nominal speed determined by the commands 70/71 is copied from DR4 to
DR3.
The result of the commands 72/73 is copied from DR4 to DR3.
The pulse parameters determined by the commands 70/71 are copied from
DR4 to DR3. The command is only used for belt scales with speed sensor.
The result of commands 60 is copied from DR4 to DR3.
The result of command 61, 63, 65 or 69 is copied from DR4 to DR3.
Description
Start trace recording
Stop trace recording
Create single trace (current state)
Delete trace recording memory
Description
Enable increased resolution on the main display and the SecureDisplay (x
10), for duration of 5 s
Displays the weight currently present on the scale
Displays the current flow rate in % of the design flow rate from DR3
Displays the current belt load
Displays the current belt load in % of the nominal belt load from DR31
Displays the current belt speed
Displays the current belt speed in % of the design speed from DR3
Displays the current master totalizer
Displays the current main totalizer
Displays the current totalizer S3
Displays the current totalizer S4
Displays the current totalizer S5
Shows the current totalizer S6
Displays the entered calibration regulations
SIWAREX WP241
Manual, 04/2014, A5E33713528A