Outside Panel; Outside Panel Assembly; Zoom Seesaw Assembly - Sony PMW-160 Service Manual

2-5.

Outside Panel

2-5-1.

Outside Panel Assembly

Preparation
1. Remove the battery lid. (Refer to
2. Remove the bottom cover. (Refer
Procedure
1. Remove the seven precision screws.
2. Remove the two claws and remove the outside panel assembly in the arrow direction.
3. Disconnect the harness from the connector CN100 on the IO-254 board.
4. Disconnect the flexible flat cable and the harness from the two connector CN500, CN501 on the IFC-13 board to
detach the outside panel assembly.
Precision screws
(M2 x 5)
Outside panel assembly
Flexible flat cable
Note
When installing the outside panel assembly, align the phase of the slide switch (S100) on the IO-255 board and the
knob of the outside panel assembly. At the section of engagement with the inside panel, install the outside panel
assembly so that the outside panel is under the inside panel.
5. Install the removed parts by reversing steps of removal.
2-5-2.

Zoom Seesaw Assembly

Preparation
1. Remove the battery lid. (Refer to
2. Remove the bottom cover. (Refer to
3. Remove the outside panel assembly. (Refer to
PMW-160/PMW-150/PMW-EX260
"2-2. Lithium Battery".)
to"2-3. Bottom Cover and Tripod
IO-254 board
CN100
Claws
Harness
Precision screws
(M2 x 5)
IFC-13 board
"2-2. Lithium Battery".)
"2-3. Bottom Cover and Tripod
"2-5-1. Outside Panel
Washer".)
Section of
Outside
engagement
panel
Harness
IO-255 board
Slide switch (S100)
Washer".)
Assembly".)
Inside panel
CN500
CN501
2-9