2.
Remove the helical torsion coil spring to detach the SxS lid assembly.
Tapping screw (2 x 5)
Helical torsion coil spring
Tapping screw (2 x 5)
Lid shaft retainer
3.
Install the removed parts by reversing steps of removal.
2-4-4.
AU Cover Sub Assembly
Preparation
1.
Remove the battery lid. (Refer to
2.
Remove the bottom cover. (Refer to
3.
Remove the inside panel assembly. (Refer to
Procedure
1.
Remove the tapping screw (2 x 5) and the washer to detach the AU shaft retainer.
2.
Remove the two parallel pins to detach the AU cover sub assembly.
Note
The parallel pins are press-fit. Use a tool to remove them.
Parallel pin
Tapping screw
(2 x 5)
Washer
AU shaft retainer
Parallel pin
PMW-160/PMW-150/PMW-EX260
Lid shaft retainer
SxS lid assembly
"2-2. Lithium
Battery".)
"2-3. Bottom Cover and Tripod
"2-4-1. Inside Panel
AU cover sub assembly
Washer".)
Assembly".)
2-7