2-7.
Outside Section
2-7-1.
Outside Panel Assembly
Preparation
1.
Remove the VF assembly. (Refer to
2.
Remove the bottom panel assembly. (Refer to
Procedure
1.
Remove the six screws and pull out the outside panel assembly in the direction of the arrow.
2.
Disconnect the two harnesses from the connector on IO-258 board and connector on IO-260 board and detach the
outside panel assembly.
3.
Install the removed parts by reversing the steps of removal.
PMW-300
"2-3-1. VF
Assembly")
"2-5. Bottom Panel
Harnesses
P2 x 5
Assembly")
Outside panel assembly
P2 x 5
Connector
(IO-260 board)
Connector
(IO-258 board)
P2 x 5
2-25