9.
Remove the four screws (P2.6 x 5) to detach the front frame S.
Front frame S
Outside
bottom bracket
Precision screw (M2 x 4)
Precision screw (M2 x 4)
Main gasket C
10. Remove the two precision screws (M2 x 4) to detach the heat sink (B).
11. Remove the two screws (TP2 x 5) to detach the plate prism radiation.
12. Remove the sheet BI copper.
13. Remove the plate prism transfer.
Note
• Carefully remove the plate prism radiation so as not to hit it against the BI boards.
• Carefully remove the sheet BI copper so as not to add stress to the BI boards.
Heat sink (B)
Precision screws (M2 x 4)
14. Remove the tapping screw to detach the clamper BI harness.
PMW-160/PMW-150/PMW-EX260
P2.6 x 5
Heat sink (A)
Ground plate (A)
Precision screw (M2 x 4)
Plate prism transfer
Plate prism radiation
TP2 x 5
Ground plate (B)
Sheet BI copper
BI boards
P2.6 x 5
2-40