Inside Panel; Inside Panel Assembly; Sw-1577/Sw-1578/Sw-1579 Board - Sony PMW-160 Service Manual

2-4.

Inside Panel

2-4-1.

Inside Panel Assembly

Preparation
1. Remove the battery lid. (Refer to
2. Remove the bottom cover. (Refer to
Procedure
1. Remove the four screws (M2 x 5) and the two claws and open the SxS lid.
2. Pull out the inside panel assembly in the arrow direction.
3. Disconnect the flexible board from the connector CN101 on the SWC-54 board and remove the inside panel
assembly.
4. Detach the AU cover.
CN101
(SWC-54 board)
Section of
Outside
engagement
panel
Note
Align the phase of the slide switch and the knob. At the section of engagement with the outside panel, install the
inside panel so that the inside panel is above the outside panel.
5. Install the removed parts by reversing steps of removal.
2-4-2.

SW-1577/SW-1578/SW-1579 Board

Preparation
1. Remove the battery lid. (Refer to
2. Remove the bottom cover. (Refer to
3. Remove the inside panel assembly. (Refer to
PMW-160/PMW-150/PMW-EX260
"2-2. Lithium Battery".)
"2-3. Bottom Cover and Tripod
Slide switches
AU cover
Flexible board
Inside panel
Claw
"2-2. Lithium Battery".)
"2-3. Bottom Cover and Tripod
"2-4-1. Inside Panel
Washer".)
Pay attention to interference with SxS slot
assembly during installation.
Precision screws
(M2 x 5)
SxS lid
Knobs
Inside panel assembly
Claw
Precision screws
(M2 x 5)
Washer".)
Assembly".)
2-4