Board; Inside Panel Assembly/Outside Panel Assembly - Sony PMW-EX1 Service Manual

2-2-6. BP-43 Board
1. Refer to Sections from 2-2-1 to 2-2-2 and
disassemble the unit up to "Case Bottom L/R
and Front Panel Assembly" removal.
2. Remove the two screws of a, and
disconnect the harness from the connector
(CN1) on the BP-43 board.
3. Remove the three screws of b, and remove
the BP-43 board.
4. Reinstall the BP-43 board by reversing the
steps of removal.
n
When installing the bottom support, align the
reference holes that are indicated as "A" and
"B" in the figure with the protrusions of the
unit.
2-2-7. Inside Panel Assembly/Outside
Panel Assembly
1. Refer to Sections from 2-2-1 to 2-2-5 and
disassemble the unit up to "Handle Assem-
bly" removal.
2. Remove the three screws a, and remove the
inside panel assembly.
3. Remove the three screws b, and remove the
outside panel assembly.
n
When removing the outside panel assembly,
be careful not to drop the battery release
button.
4. Reinstall the inside panel assembly/outside
panel assembly by reversing the steps of
removal.
2-6
Bottom support
a
BP-43 board
CN1
b
b
a
: P2 lock ace 2 x 3
b
: P2 lock ace 1.4 x 2.5
a
Inside panel
assembly
A
Harness
B
a
: P2 lock ace
a
b
: P2 lock ace
Battery
release button
b
2 x 3
2 x 3
b
Outside panel
assembly
PMW-EX1