Main Chassis; If-1182 Board; Board - Sony PMW-160 Service Manual

2-16.

Main Chassis

2-16-1.

IF-1182 Board

Preparation
1. Remove the battery lid. (Refer to
2. Remove the bottom cover. (Refer to
3. Remove the inside panel assembly. (Refer to
4. Remove the outside panel assembly. (Refer to
5. Remove the top panel assembly. (Refer to
Procedure
1. Peel off the tape.
2. Disconnect the HN-387 board from the connector CN102 on the IF-1182 board.
3. Disconnect the flexible flat cable from the connector CN103 on the IF-1182 board.
4. Remove the two precision screws (M2 x 4).
5. Disconnect the HN-386 board from the connector CN100 on the IF-1182 board to detach the IF-1182 board.
CN102
CN100
IF-1182 board
HN-387 board
HN-386 board
6. Install the removed parts by reversing steps of removal.
2-16-2. DPR-343 Board
Preparation
1. Remove the battery lid. (Refer to
2. Remove the bottom cover. (Refer to
3. Remove the inside panel assembly. (Refer to
4. Remove the outside panel assembly. (Refer to
5. Remove the top panel assembly. (Refer to
6. Remove the SxS slot assembly. (Refer to
7. Remove the front panel assembly. (Refer
8. Remove the rear panel assembly. (Refer to
9. Remove the IO-255 assembly. (Refer
10. Remove the DCP-56 board. (Refer to
PMW-160/PMW-150/PMW-EX260
"2-2. Lithium Battery".)
"2-3. Bottom Cover and Tripod
"2-4-1. Inside Panel
"2-5-1. Outside Panel
"2-6. Top Panel Assembly".)
Precision screw
(M2 x 4)
CN103
Precision screw
(M2 x 4)
"2-2. Lithium Battery".)
"2-3. Bottom Cover and Tripod
"2-4-1. Inside Panel
"2-5-1. Outside Panel
"2-6. Top Panel Assembly".)
"2-7-1. SxS Slot Assembly".)
to"2-8-1. Front Panel
"2-9. Rear Panel Assembly".)
to"2-11. IO-255

Board".)

"2-12. DCP-61 Board".)
Washer".)
Assembly".)
Assembly".)
Tape
Flexible flat cable
Washer".)
Assembly".)
Assembly".)
Assembly".)
2-44