Sony PMW-160 Service Manual page 69

7. Remove the front panel assembly. (Refer to
8. Remove the rear panel assembly. (Refer to
9. Remove the IO-255 assembly. (Refer to
10. Remove the DCP-61 board. (Refer to
11. Remove the handle assembly. (Refer to
12. Remove the front lens assembly. (Refer to
Procedure
1. Remove the tape.
2. Remove the two precision screws (M2 x 4) to detach the SE-1110 board.
3. Remove the two screws (TP2 x 5) to detach the GY bracket S.
SE-1110 board
Precision screws
(M2 x 4)
4. Remove the main gasket C.
5. Remove the precision screw (M2 x 4) to detach the ground plate (A).
6. Remove the precision screw (M2 x 4) to detach the heat sink (A).
7. Remove the precision screw (M2 x 4) to detach the ground plate (B).
8. Remove the screw (P2.6 x 5) to detach the outside bottom bracket.
PMW-160/PMW-150/PMW-EX260
"2-8-1. Front Panel
"2-9. Rear Panel
"2-11. IO-255 Board".)
"2-12. DCP-61 Board".)
"2-13-1. Handle Assembly".)
"2-14-1. Front Lens
TP2 x 5
Tape
Assembly".)
Assembly".)
Assembly".)
GY Bracket S
2-39