Outside Panel; Outside Panel Assembly; Zoom Seesaw Assembly - Sony PMW-200 Service Manual

2-5.

Outside Panel

2-5-1.

Outside Panel Assembly

Preparation
1. Remove the battery lid. (Refer to
2. Remove the bottom cover. (Refer
Procedure
1. Remove the six precision screws (M2 x 5) and the two precision screws (M2.6 x 5).
2. Remove the two claws and remove the outside panel assembly in the arrow direction.
3. Disconnect the harness from the connector CN100 on the IO-254 board.
4. Disconnect the harness and the flexible flat cable from the two connectors CN102, CN104 on the CN-3540 board
and remove the outside panel assembly.
Outside panel assembly
Precision screw
(M2.6 x 5)
Flexible flat cable
Note
When installing the outside panel assembly, align the phase of the slide switch (S100) on the IO-255 board and the
knob of the outside panel assembly. At the section of engagement with the inside panel, install the outside panel
assembly so that the outside panel is under the inside panel.
5. Install the removed parts by reversing steps of removal.
2-5-2.

Zoom Seesaw Assembly

Preparation
1. Remove the battery lid. (Refer to
2. Remove the bottom cover. (Refer to
PMW-200/PMW-EX280
"2-2. Lithium Battery".)
to"2-3. Bottom Cover and Tripod
CN100
Precision screw
(M2 x 5)
Claws
Precision screw
(M2 x 5)
Harness
"2-2. Lithium Battery".)
"2-3. Bottom Cover and Tripod
Washer".)
Section of
Outside
engagement
panel
IO-254 board
IO-255 board
Slide switch (S100)
CN104
Washer".)
Inside panel
Harness
CN102
CN3540 Board
2-9