Security; Targets Menu; Target Messages - GE UR F35 Series Instruction Manual

7.1 COMMANDS
i 
PATH: COMMANDS
 SECURITY

With the CyberSentry option, this setting is available to enable or disable the following commands:
• Administrator Logoff: Selecting 'Yes' allows the Supervisor to forcefully logoff an administrator session.
• Engineer Logoff: Selecting 'Yes' allows the Supervisor to forcefully logoff an engineer session.
• Operator Logoff: Selecting 'Yes' allows the Supervisor to forcefully logoff an operator session.
• Clear Security Data: Selecting 'Yes' allows the Supervisor to forcefully clear all the security logs and clears all the
operands associated with the self-tests.
Targets
7
Each F35 element with a TARGET setting has a target message that when activated by its element is displayed in
sequence with any other currently active target messages in the
and Digital Element 48 target settings are active and so have their targets displayed. The down arrow below the two ele-
ments indicates that there can be other active elements beyond these two.
For more information, see the description of target messages in the next section, and the Introduction to Elements section
in the Settings chapter for instructions on TARGET setting.
When no targets are active, the display reads
When there are no active targets, the first target to become active will cause the display to immediately default to that mes-
sage. If there are active targets and the user is navigating through other messages, and when the default message timer
times out (i.e. the keypad has not been used for a determined period of time), the display will again default back to the tar-
get message.
7-4

SECURITY

ADMINISTRATOR
LOGOFF: No
ENGINEER
LOGOFF: No
OPERATOR
LOGOFF: No
CLEAR SECURITY DATA:
PHASE TOC4
MESSAGE
OP: A B -
DIGITAL ELEMENT 48:
MESSAGE
LATCHED
MESSAGE
NO TARGETS
F35 Multiple Feeder Protection System
Range: Yes, No
Default: No
Range: Yes, No
Default: No
Range: Yes, No
Default: No
Range: Yes, No
Default: No
TARGETS

Displayed only if targets for this element are active.
Example shown.
Displayed only if targets for this element are active.
Example shown.

menu. In the example shown, the Phase TOC4
TARGETS
.
7 COMMANDS AND TARGETS
7.1.6 SECURITY

7.1.7 TARGETS MENU

7.1.8 TARGET MESSAGES

GE Multilin