GE UR F35 Series Instruction Manual page 197

5 SETTINGS
To use SNTP in unicast mode,
set and is "Enabled," the F35 attempts to obtain time values from the SNTP/NTP server. Since many time
SNTP FUNCTION
values are obtained and averaged, it generally takes three to four minutes until the F35 clock is closely synchronized with
the SNTP/NTP server. It takes up to two minutes for the F35 to signal an SNTP self-test error if the server is offline.
To use SNTP in broadcast mode, set the
F35 then listens to SNTP messages sent to the "all ones" broadcast address for the subnet. The F35 waits up to 18 minutes
(>1024 seconds) without receiving an SNTP broadcast message before signaling an SNTP self-test error.
The
SNTP UDP PORT NUMBER
When the
SNTP UDP PORT NUMBER
NOTE
d) LOCAL TIME

PATH: SETTINGS PRODUCT SETUP
 LOCAL TIME

MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
The UR device maintains two times: local time and Universal Coordinated Time (UTC). Local time can be provided by IRIG-
B signals. UTC time is provided by SNTP servers.
The real-time clock (RTC) and time stamps reported in historical records and communication protocols can be incorrect if
the Local Time settings are not configured properly.
See the IRIG-B section in the Installation chapter for guidance on these settings when using an IRIG-B source that sets the
IRIG-B control bits according to IEEE Std 1344-1995.
The
LOCAL TIME OFFSET FROM UTC
hours. Time zones in the eastern hemisphere have positive values; time zones in the western hemisphere have negative
values. A value of zero causes the relay to use UTC for local time. This setting has two uses. When the system RTC is syn-
chronized with a communications protocol providing only local time or it is free-running, the offset setting is used to calcu-
late UTC from the local time these provide. When the RTC is synchronized with a communications protocol providing only
UTC (such as PTP or SNTP), the time offset setting is used to determine local time from the UTC provided. PTP
ALTERNATE_TIME_OFFSET_INDICATOR TLVs are not used to calculate local time.
GE Multilin
must be set to the SNTP/NTP server IP address. Once this address is
SNTP SERVER IP ADDR
SNTP SERVER IP ADDR
is 123 for normal SNTP operation. If SNTP is not required, close the port by setting it to 0.
is set to 0, the change takes effect when the F35 is restarted.
 
REAL TIME CLOCK
LOCAL TIME OFFSET
FROM UTC: 0.0 hrs
DAYLIGHT SAVINGS
TIME: Disabled
DST START MONTH:
January
DST START DAY:
Sunday
DST START DAY
INSTANCE: First
DST START HOUR:
2
DST STOP MONTH:
January
DST STOP DAY:
Sunday
DST STOP DAY
INSTANCE: First
DST STOP HOUR:
2
setting is used to specify the local time zone offset from UTC (Greenwich Mean Time) in
F35 Multiple Feeder Protection System
setting to "0.0.0.0" and
SNTP FUNCTION
LOCAL TIME
Range: –24.0 to 24.0 hrs in steps of 0.5
Range: Disabled, Enabled
Range: January to December (all months)
Range: Sunday to Saturday (all days of the week)
Range: First, Second, Third, Fourth, Last
Range: 0 to 23
Range: January to December (all months)
Range: Sunday to Saturday (all days of the week)
Range: First, Second, Third, Fourth, Last
Range: 0 to 23
5.2 PRODUCT SETUP
to "Enabled." The
5
5-69