GE UR F35 Series Instruction Manual page 127

4 HUMAN INTERFACES
The F35 supports password entry from a local or remote connection.
Local access is defined as any access to settings or commands via the faceplate interface. This includes both keypad entry
and the faceplate RS232 connection. Remote access is defined as any access to settings or commands via any rear com-
munications port. This includes both Ethernet and RS485 connections. Any changes to the local or remote passwords
enables this functionality.
To enter the initial setting (or command) password, proceed as follows:
1. Press the MENU key until the
display.
2. Press the MESSAGE RIGHT key until the
3. Press the MESSAGE DOWN key until the
4. Press the MESSAGE RIGHT key until the
appears on the display.
 SECURITY

5. After the
CHANGE...PASSWORD
selection to "Yes".
6. Press the ENTER key and the display prompts you to
7. Type in a numerical password (up to 10 characters) and press the ENTER key.
8. When the
VERIFY NEW PASSWORD
CHANGE SETTING
PASSWORD: No
CHANGE SETTING
PASSWORD: Yes
9. When the
NEW PASSWORD HAS BEEN STORED
active.
f) CHANGING EXISTING PASSWORD
To change an existing password, follow the instructions in the previous section with the following exception. A message
prompts you to type in the existing password (for each security level) before a new password can be entered.
g) INVALID PASSWORD ENTRY
By default, when an incorrect Command or Setting password has been entered via the faceplate interface three times
within three minutes, the
LOCAL ACCESS DENIED
command level access via the faceplate interface for the next five minutes.
GE Multilin
header flashes momentarily and the
SETTINGS
message appears on the display.
ACCESS LEVEL
CHANGE LOCAL PASSWORDS
CHANGE SETTING PASSWORD
ACCESS LEVEL:
Restricted
 CHANGE LOCAL
 PASSWORDS
message appears on the display, press the VALUE UP or DOWN key to change the
ENTER NEW PASSWORD
is displayed, re-type in the same password and press ENTER.
ENTER NEW
PASSWORD: ##########
message appears, your new Setting (or Command) Password will be
FlexLogic operand is set to "On" and the F35 does not allow settings or
F35 Multiple Feeder Protection System
4.3 FACEPLATE INTERFACE
message appears on the
PRODUCT SETUP
message appears on the display.
or
CHANGE COMMAND PASSWORD
CHANGE COMMAND
PASSWORD: No
CHANGE SETTING
PASSWORD: No
ENCRYPTED COMMAND
PASSWORD: ---------
ENCRYPTED SETTING
PASSWORD: ---------
.
VERIFY NEW
PASSWORD: ##########
NEW PASSWORD
HAS BEEN STORED
message
4
4-29