GE UR F35 Series Instruction Manual page 268

Multiple feeder protection system

Hide thumbs Also See for UR F35 Series:

Table of Contents

5.5 FLEXLOGIC

Table 5–18: FLEXELEMENT BASE UNITS

SOURCE ENERGY

(Positive and Negative Watthours,

Positive and Negative Varhours)

SOURCE POWER

SOURCE VOLTAGE

FLEXELEMENT 1 HYSTERESIS

hysteresis loop as a percentage of the pickup value as shown in the FlexElement direction, pickup, and hysteresis diagram.

FLEXELEMENT 1 DT UNIT

FLEXELEMENT 1 COMP MODE

rate of change mode of operation. This setting is applicable only if

FLEXELEMENT 1 PKP DELAY

specifies the reset delay of the element.

= 10000 MWh or MVAh, respectively

= maximum value of V

= maximum nominal primary RMS value of the +IN and –IN inputs

setting defines the pickup–dropout relation of the element by specifying the width of the

setting specifies the time unit for the setting

is set to "Delta". The

FLEXELEMENT 1 DT

setting specifies the pickup delay of the element. The

F35 Multiple Feeder Protection System

for the +IN and –IN inputs

. This setting is applicable only if

FLEXELEMENT 1 dt

setting specifies duration of the time interval for the

FLEXELEMENT 1 COMP MODE

FLEXELEMENT 1 RST DELAY

is set to "Delta".