Application - Danfoss ECL Comfort 310 Operating Manual

Operating Guide

5.7 Application

The section "Application" describes specific application related
issues.
Some of the parameter descriptions are universal for different
application keys.
Parameters indicated with an ID no. like "1x607" mean a universal
parameter.
x stands for circuit / parameter group.
MENU > Settings > Application
DHW P post-run (DHW pump, post-run)
Circuit
All
Set the DHW pump post-run time (minutes). The DHW pump can continue
to be switched ON after the DHW heating procedure in order to utilize the
remaining heat in the heat exchanger / boiler.
Post-run is cancelled if the charging temperature S3 gets lower than the
desired temperature at S6.
* See Appendix "Parameter ID overview"
Value: Set the number of minutes for the post-run.
MENU > Settings > Application
Cont. T control (Continued temperature control)
Circuit
All
The desired DHW temperature at S6 can be maintained at S3 after the buffer
charging procedure has elapsed.
* See Appendix "Parameter ID overview"
OFF:
The desired temperature at S6 is not maintained at S3.
The control valve closes / control pump stops.
ON: The desired temperature at S6 is maintained at S3.
MENU > Settings > Application
Mon. T select (Monitoring temperature, selection)
Circuit
All
The DHW temperature, shown in Favorite display 1, can be a selected
temperature sensor.
* See Appendix "Parameter ID overview"
Select the desired temperature sensor.
76 DEN-SMT/DK
ECL Comfort 310, application P318
1x041
Setting range Factory setting
*
1x054
Setting range Factory setting
*
1x145
Setting range Factory setting
*
*
*
*
VI.JM.Q3.02
Danfoss District Energy