Danfoss ECL Comfort 310 Operating Manual page 72

Operating Guide
MENU > Settings > Boiler
MENU > Settings > Control par.
MENU > Settings > Control par., cool.
MENU > Settings > Control par. 1
MENU > Settings > Control par. 2
Min. act. time (min. activation time gear motor)
Circuit
All
The min. pulse period of 20 ms (milliseconds ) for activation of the gear
motor.
* See Appendix "Parameter ID overview"
MENU > Settings > Control par. 1
Wake up level
Circuit
All
If the control valve has been closed after a charging, it will be opened to
the set value at next charging. Then await an acceptable S2 temperature
before switching ON the charging pump. The opening position is the value
(percentage) of the M.run (Motor running time).
If the control pump has been stopped after a charging, it will start with a
speed level as the set value at next charging. Then await an acceptable S2
temperature before switching ON the charging pump.
* See Appendix "Parameter ID overview"
MENU > Settings > Control par. 1
CW influence (Cold Water influence)
Circuit
1
The cold water flow (measured by Cold Water meter F1) can influence the
DHW temperature control by overriding the control of the motorized control
valve. By this, the temperature control is pro-active and compensates for
the delay before the flow temperature sensor S3 measures a change in
temperature.
The value expresses how many % of 100 liters / hour will do an influence on
the motorized control valve.
* See Appendix "Parameter ID overview"
Low
Minor influence
value:
High Major influence
value:
72 DEN-SMT/DK
ECL Comfort 310, application P318
1x189
Setting range Factory setting
*
1x330
Setting range Factory setting
*
1x354
Setting range Factory setting
*
Setting example
2
10
50
*
The setting should be kept as high as acceptable to increase the
lifetime of the actuator (gear motor).
*
*
VI.JM.Q3.02
Value x 20 ms
40 ms
200 ms
1000 ms
Danfoss District Energy