Danfoss ECL Comfort 310 Operating Manual page 60

Operating Guide
MENU > Settings > Flow temperature
MENU > Settings > Inlet temperature
Temp. min.
Circuit
All
* See Appendix "Parameter ID overview"
Set the min. duct / flow / inlet temperature for the system. The
desired duct / flow / inlet temperature will not be lower than this
setting. Adjust the factory setting, if required.
MENU > Settings > Flow temperature
MENU > Settings > Inlet temperature
Temp. max.
Circuit
All
* See Appendix "Parameter ID overview"
Set the max. flow / duct / inlet temperature for the system. The
desired temperature will not be higher than this setting. Adjust
the factory setting, if required.
60 DEN-SMT/DK
ECL Comfort 310, application P318
1x177
Setting range Factory setting
*
1x178
Factory setting
Setting range
*
'Temp. min. ' is overruled if 'Total stop' is active in Saving mode or
'Cut-out' is active.
'Temp. min. ' can be overruled by the influence from the return
temperature limitation (see 'Priority').
*
The setting for 'Temp. max. ' has higher priority than 'Temp. min. ' .
The setting of 'heat curve' is possible for heating circuits only.
*
The setting for 'Temp. max. ' has higher priority than 'Temp. min. ' .
VI.JM.Q3.02
Danfoss District Energy