Danfoss ECL Comfort 310 Operating Manual page 111

Operating Guide
ECA MENU > ECA system > ECA display
Contrast (display contrast)
Setting range
0 ... 10
Adjust the contrast of the display.
0: Low contrast.
10:
High contrast.
ECA MENU > ECA system > ECA display
Use as remote
Setting range
OFF / ON
ECA 30 / 31 can act as a simple or normal remote control
for the ECL controller.
OFF:
Simple remote control, no room temperature signal.
ON: Remote control, room temperature signal is available.
*): Differently, depending on chosen application.
ECA MENU > ECA system > ECA communication
Slave addr. (Slave address)
Setting range
A / B
The setting of 'Slave addr. ' is related to the setting 'ECA
address' in the ECL controller.
In the ECL controller it is selected from which ECA 30 / 31
unit the room temperature signal is received.
A: The ECA 30 / 31 has the address A.
B: The ECA 30 / 31 has the address B.
Danfoss District Energy
ECL Comfort 310, application P318
Factory setting
3
Factory setting
*)
Factory setting
A
When set to OFF: The ECA menu shows date and time.
When set to ON: The ECA menu shows date and room temperature
(and for ECA 31 relative humidity).
For installation of an application in an ECL Comfort 210 / 296 / 310
controller the 'Slave addr.' must be A.
If two ECA 30 / 31 are connected in the same ECL 485 bus system, the
'Slave addr.' must be "A" in the one ECA 30 / 31 unit and "B" in the other.
VI.JM.Q3.02
DEN-SMT/DK 111