Set Config Command; B-7 Set Config Port Parameters - Qlogic SANbox2-16 Fibre Channel Installation Manual



Set Config Command

Sets switch, port, alarm threshold, and zoning configuration parameters.
Authority
Admin authority and a Config Edit session
Syntax
set config
port [port_number]
ports [port_number]
switch
threshold
zoning
Keywords
port [port_number]
Initiates an edit session in which to change configuration parameters for the port
number given by [port_number]. If you omit [port_number], the system begins with
port 0 and proceeds in order through the last port. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
Enter "q" to cancel the configuration for one port, or "qq" to cancel the
configuration for all ports.
ports [port_number]
Initiates an editing session in which to change configuration parameters for all
ports based on the configuration for the port given by [port_number]. If you omit
[port_number], port 0 is used. For each parameter, enter a new value or press the
Enter key to accept the current value shown in brackets. Enter "q" to cancel the
configuration.
AdminState
LinkSpeed
PortType
TLPortMode
ISLSecurity
SymbolicPortName
59021-05 A
Table B-7
Table B-7 describes the port parameters.
Table B-7. Set Config Port Parameters
Parameter
B – Command Line Interface
describes the port parameters.
Description
Port administrative state: online, offline,
diagnostics, or down.
1Gb/sec or 2 Gb/sec
Type of port
Configures a TL_Port for a loop of
private target or initiator devices.
E_Port security. Determines which
switches a port will establish a link with.
Any - link with any FC-SW-2
compliant switch.
Ours - link only with an FC-SW-2
compliant QLogic switch.
None - reject the link.
Descriptive name
Set Config Command
B-25