Qlogic SANbox2-8c Installation Manual page 141

D
The following is an example of the Show Interface command:
SANbox2 #> show interface
eth0
lo
59042-03 A
Link encap:Ethernet HWaddr 00:C0:DD:00:BD:ED
inet addr:10.20.68.107
UP BROADCAST RUNNING MULTICAST
RX packets:4712 errors:0 dropped:0 overruns:0 frame:0
TX packets:3000 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:415313 (405.5 Kb)
Interrupt:11 Base address:0xfcc0
Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436
RX packets:304 errors:0 dropped:0 overruns:0 frame:0
TX packets:304 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:20116 (19.6 Kb)
Bcast:10.20.68.255 Mask:255.255.255.0
MTU:1500 Metric:1
TX bytes:716751 (699.9 Kb)
Metric:1
TX bytes:20116 (19.6 Kb)
B – Command Line Interface
Show Command
B-55