Table of Contents
Advertisement
D
Fallback Command
Assigns the pending firmware status back and forth between the active and
inactive firmware images stored in switch memory.
Authority
Admin
Syntax
fallback
Notes
The Show Switch command displays the two firmware images, active
firmware, inactive firmware, and pending firmware versions.
After executing the Fallback command, reset the switch to activate the
pending firmware. Use the Hotreset command for a non-disruptive
activation. Otherwise, you can use the Reset Switch command.
Examples
The following is an example of the Fallback command:
SANbox2 #> admin start
SANbox2 (admin) #> fallback
Reverting to previous software image.
59042-03 A
B – Command Line Interface
Please confirm (y/n): [n] y
Fallback Command
B-11
Advertisement
Table of Contents
Need help?
Do you have a question about the SANbox2-8c and is the answer not in the manual?