Table of Contents
Advertisement
4 – Installation
Installing a Switch
4.2.2
Install SFP Transceivers
The switch has been validated with transceivers that support a variety of
interconnection media. To install, insert the transceiver into the port and gently
press until it snaps in place. To remove a transceiver, gently press the transceiver
into the port to release the tension, then pull on the release tab or lever and
remove the transceiver. Different transceiver manufacturers have different release
mechanisms. Consult the documentation for your transceiver.
Note:
4.2.3
Connect the Switch to AC Power
WARNING!!
4-4
The SFP transceiver will fit only one way. If the SFP does not install
under gentle pressure, flip it over and try again.
This product is supplied with a 3-wire power cable and plug for
the user's safety. Use this power cable in conjunction with a
properly grounded outlet to avoid electrical shock. An electrical
outlet that is not correctly wired could place hazardous voltage
on metal parts of the switch chassis. It is the responsibility of the
customer to ensure that the outlet is correctly wired and
grounded to prevent electrical shock.
You may require a different power cable in some countries
because the plug on the cable supplied with the equipment will
not fit your electrical outlet. In this case, you must supply your
own power cable. The cable you use must meet the following
requirements:
For 125 Volt electrical service, the cable must be rated at
10 Amps and be approved by UL and CSA.
For 250 Volt electrical service: The cable must be rated at
10 Amps, meet the requirements of H05VV-F, and be
approved by VDE, SEMKO, and DEMKO.
D
59042-03 A
Advertisement
Table of Contents
