Configuring Ethernet Settings
to select <Network Settings>, and press
If the logon screen appears, enter the correct ID and PIN using the numeric keys, and then press
Logging on to the Machine(P. 34)
Select <Ethernet Driver Settings>
Select whether to configure Ethernet settings automatically or manually.
Configuring Ethernet settings automatically
Select <On> and press
Ethernet type that can be used.
Configuring Ethernet settings manually
Select <Off>, and press
Select the communication mode.
Select <Communication Mode>
Alternately sends and receives communication data. Select when the machine is connected to a
networking device using half duplex.
Simultaneously sends and receives communication data. Use this setting for most environments.
Ethernet is a standard for communicating data in a local area network (LAN). You can set
the communication mode (half-duplex/full-duplex) and the Ethernet type (10BASE-T/
100BASE-TX/1000BASE-T). In general, the machine can be used without changing the
Ethernet Driver Settings(P. 299) ), but you can change these settings to suit
your network environment.
. The machine detects and automatically sets the communication mode and the
Select <Half Duplex> or <Full Duplex>