Select <DHCP>, and press
If you do not want to use DHCP/BOOTP/RARP to assign an IP address
Select <Off>, and press
the machine will waste time and communications resources searching the network for these services.
Check that <Auto IP> is set to <On>.
If <Off> is selected, change the setting to <On>.
Select <Apply>, and press
IP addresses assigned via DHCP override the address obtained via Auto IP.
Manually entering an IP address
Check that <Auto Acquire> is set to <Off>.
If <On> is displayed, select <Auto Acquire>, press
Select <Manually Acquire>, and press
Specify the IP address, subnet mask, and gateway address (or default gateway).
Specify the settings in the following order: <IP Address>
Enter each setting using the numeric keys, and press
Restart the machine.
Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
Checking whether the settings are correct
Make sure that the Remote UI screen can be displayed with your computer (
If a computer is not available, you can check the connection by using the operation panel (
Network Connection(P. 156) ).
. If you select <DHCP> and press
when these services are unavailable,
, and set both <Select Protocol> and <Auto IP> to
Starting Remote UI(P. 270) ).