Error Ratio: F3 - Omron K3NR Operation Manual

Error Ratio: f3

Hold Measured Value
Performance Characteristics
Accuracy of measurement
Measurement range
ON/OFF pulse width
Response time
Relay output
Comparative output 200 ms max.
BCD output ---
Linear output ---
When the HOLD input is turned ON, measurement stops and the input mea-
sured just before the HOLD input turned ON is held. While the HOLD input is
ON, the K3NR holds display output, comparative output, and BCD output.
When the comparative output from the Output Board is connected to the
HOLD input terminal, the value measured immediately after the occurrence
of an error can be obtained.
±
±0.02% rdg
1 digit (ambient temperature: 23°C
Sensor with transistor output: 0.5 mHz to 50 kHz
Sensor with relay output: 0.5 mHz to 30 Hz
Sensor with transistor output: 9
Sensor with relay output: 15 ms min.
Output configuration
Transistor
output transistor output
--- Refer to page 115. ---
--- ---
±
µ
s min.
BCD and Linear and
transistor output
220 ms max.
Section 3-3
5°C)
Communication
and transistor
output
---
---
29