Sony DVS-9000 System User Manual page 433

3
Turn [Graphic] on.
The system enters graphics display mode, enabling graphics to be
displayed in the monitor screen.
4
Turn on the buttons of the graphics you want to show.
To show axes: Turn [Axis] on.
To show axis names: Turn [Axis Name] on.
To show the channel ID: Turn [Ch ID] on.
To show a wire frame: Turn [Wire Frame] on.
To show the grid: Turn [Grid] on.
To show the flex shadow axis: Turn [Flex Shadow Axis] on.
The selected graphics appear in the monitor screen.
Note
The flex shadow axis function is not supported on the MVE-8000A.
5
If you want to shrink the graphics display to show the range not displayed
on a normal monitor, turn [Scale] on and set the following parameters.
Knob
1
As the value of the setting grows, the monitor shrinks further toward the
center point.
6
To automatically erase the graphic display while the keyframes are
executing, press [Auto Erase], turning it on, and then set the following
parameter.
Knob
1
Outputting graphics to the monitor output connector
In the Graphic menu, press [Monitor Out] to turn it on.
Graphics are displayed on the device connected to the monitor output
connector.
Note
Output to the Monitor Out connector is not supported with the BKDS-9470.
Parameter Adjustment
Scale Degree to which the graphics
display is shrunk
Parameter Adjustment
Recover Time Time until graphic display
appears again after keyframe
execution
Setting values
0.00 to 100.00
Setting values
0 to 300 (frames)
Three-Dimensional Transformation Operations
433