3
4
Making safe title settings
1
2
3
4
5
952
Signal Output Settings (Output Menu)
Adjust the parameter.
Knob
Parameter
Adjustment
2
Mask End
Final value for vertical blanking
interval
a) Depending on the signal format, the adjustment range varies as follows.
• 480i: 10 to 19
• 576i: 6 to 22
To return the values to their defaults, press [Default].
To enable the through mode, press [Through Mode], setting it to Enable.
The through mode can be applied to the following outputs.
• Aux 1 to 48 outputs
• Program outputs of the M/E and PGM/PST rows
• Clean outputs of the M/E and PGM/PST rows
In the Switcher >Output menu, press [Safe Title].
The Safe Title menu appears.
The status area shows the output ports and the assigned signals, with the
box 1, box 2, and cross states.
To enable the safe title on/off setting made in the Misc menu, press [Safe
Title], turning it on.
Carry out either of the following operations.
To display a box: Press [Box1] or [Box2], turning it on.
In this case, carry out the following steps 4 and 5.
To display a cross: Press [Cross], turning it on.
When you selected [Box1] or [Box2] in step 3, adjust the following
parameters.
Knob
Parameter
Adjustment
2
Box Size
Box size
3
Luminance
Display brightness
a) Adjustable for Box2
When in step 3 you selected [Box1] or [Box2], in the <Box1 Adjust> or
<Box2 Adjust> group, select the screen aspect ratio (16:9/14:9/4:3).
Setting values
See note a) below
Setting values
50.00 to 100.00
a)
0.00 to 100.00