Sony DVS-9000 System User Manual page 655

COUNT
7
Press the [ENTER] button to confirm the entry.
The start point, end point, and loop count that you have set are reflected in
the Timeline menu.
If you enter the loop count as "0" (endless loop), the count is shown as
"inf" (infinity).
The numeric keypad control block display changes back to the state shown
in step 4.
Changing the keyframe loop settings
To change the loop range or count for the currently recalled effect, carry out
the following procedure.
1
When the [KF LOOP] button in the keyframe control block is lit amber,
press it, turning it green.
The numeric keypad control block display shows the current loop range.
If, for example, the start point is keyframe 2 and the end point is keyframe
5, this appears as follows.
FM 2 TO 5
2
To change the loop range, press the [CLEAR] button in the numeric
keypad control block.
To change the loop count only, press the [ENTER] button, then skip to step
6.
When you press the [CLEAR] button, this appears as follows.
FM
3
Enter the keyframe number for the new start point, and press the [ENTER]
button.
4
Enter the keyframe number for the new end point, and press the [ENTER]
button.
The display shows the currently set loop count.
5
To change the setting, press the [CLEAR] button.
This clears the set loop count.
COUNT
15
TO
Creating and Editing Keyframes
655