Trap Settings; Notification Recipients - Cisco 350XG series Administration Manual

SNMP

Trap Settings

Trap Settings
STEP 1
STEP 2
STEP 3
STEP 4

Notification Recipients

Cisco 350XG & 550XG Series 10G Stackable Managed Switches
The Trap Settings page enables configuring whether SNMP notifications are sent
from the device, and for which cases. The recipients of the SNMP notifications can
be configured in the
Notification Recipients
To define trap settings:
Click SNMP > Trap Settings.
Select Enable for SNMP Notifications to specify that the device can send SNMP
notifications.
Select Enable for Authentication Notifications to enable SNMP authentication
failure notification.
Click Apply. The SNMP Trap settings are written to the Running Configuration file.
Trap messages are generated to report system events, as defined in RFC 1215.
The system can generate traps defined in the MIB that it supports.
Trap receivers (aka Notification Recipients) are network nodes where the trap
messages are sent by the device. A list of notification recipients are defined as the
targets of trap messages.
A trap receiver entry contains the IP address of the node and the SNMP
credentials corresponding to the version that is included in the trap message.
When an event arises that requires a trap message to be sent, it is sent to every
node listed in the Notification Recipient Table.
The SNMPv1,2 Notification Recipients
Recipientspage enable configuring the destination to which SNMP notifications
are sent, and the types of SNMP notifications that are sent to each destination
(traps or informs). The Add/Edit pop-ups enable configuring the attributes of the
notifications.
An SNMP notification is a message sent from the device to the SNMP
management station indicating that a certain event has occurred, such as a link up/
down.
SNMPv1,2 Notification Recipients
page.
page and the
27
page, or the SNMPv3
SNMPv3 Notification
600