Cisco 350XG series Administration Manual page 599

Quality of Service
QoS Advanced Mode
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
• An action to be applied to frames that are over the limits (called out-of-
profile traffic), where such frames can be passed as is, dropped, or passed,
but remapped to a new DSCP value that marks them as lower-priority
frames for all subsequent handling within the device.
Assigning a policer to a class map is done when a class map is added to a policy.
If the policer is an aggregate policer, you must create it using the Aggregate
Policer page.
To define an aggregate policer:
Click Quality of Service > QoS Advanced Mode > Aggregate Policer.
This page displays the existing aggregate policers.
Click Add.
Enter the parameters.
• Aggregate Policer Name—Enter the name of the Aggregate Policer.
• Ingress Committed Information Rate (CIR)—Enter the maximum
bandwidth allowed in bits per second. See the description of this in the
Bandwidth page.
• Ingress Committed Burst Size (CBS)—Enter the maximum burst size (even
if it goes beyond the CIR) in bytes. See the description of this in the
Bandwidth page.
• Exceed Action—Select the action to be performed on incoming packets
that exceed the CIR. Possible values are:
- Forward—Packets exceeding the defined CIR value are forwarded.
- Drop—Packets exceeding the defined CIR value are dropped.
- Out of Profile DSCP—The DSCP values of packets exceeding the
defined CIR value are remapped to a value based on the Out Of Profile
DSCP Mapping Table.
Click Apply. The Running Configuration file is updated.
26
579