Virtual Routers - Cisco 350XG series Administration Manual

IP Configuration: VRRP
Configuring VRRP
STEP 1
STEP 2
STEP 3
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
• VRRP Statistics

Virtual Routers

VRRP properties can be configured and customized in the VRRP Virtual Routers
page.
Click IP Configuration > IPv4 Management and Interfaces > VRRP > Virtual
Routers.
To add a virtual router, click ADD.
Enter the following fields:
• Interface—Interface on which virtual router is defined.
• Virtual Router Identifier—User-defined number identifying virtual router.
• Description—User-defined string identifying virtual router.
• Status—Select to enable VRRP on the device.
• Version—Select the version of VRRP to be used on this router.
• IP Address Owner—If Yes is checked, this indicates that the IP address of
the device is the IP address of the virtual router. Select the IP addresses of
the owner from the Available IP Address list and move it to the Owner IP
Address list.
If No is checked, you must enter the address(es) of the virtual router in the
Virtual Router IP Addresses field. If multiple IP addresses are added here,
separate them as follows: 1.1.1.1, 2.2.2.2.
• Source IP Address—Select the IP address to be used in VRRP messages.
The default source IP address is the lowest of the IP addresses defined on
the interface.
• Priority—If this device is the owner, this field gets the value 255, and this
value cannot be changed. If not, enter the priority of this device, based on its
ability to function as a master. 100 is the default for a non-owner device.
• Preempt Mode—Select true/false to enable/disable preempt mode, as
described in VRRP Router Priority and
• Advertisement Interval—Enter time interval, as described in
Advertisements.
Preemption.
18
VRRP
385