Applying A Smartport Type To An Interface; Macro Failure And The Reset Operation - Cisco 350XG series Administration Manual

Smartport
Overview
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
- no_macro-name (for example: no_printer)
• User-Defined—These are macros written by the users. See the CLI
Reference Guide for more information about these. To associate a user
defined macro to a Smartport type, its anti macro must be defined as well.
- smartport-type-name (for example: my_printer)
- no_smartport-type-name (for example: no_my_printer)
Smartport macros are bound to Smartport types in the
See Built-in Smartport Macros
each device type.

Applying a Smartport Type to an Interface

When Smartport types are applied to interfaces, the Smartport types and
configuration in the associated Smartport macros are saved in the Running
Configuration File. If the administrator saves the Running Configuration File into the
Startup Configuration File, the device applies the Smartport types and the
Smartport macros to the interfaces after reboot as follows:
• If the Startup Configuration File does not specify a Smartport type for an
interface, its Smartport type is set to Default.
• If the Startup Configuration File specifies a static Smartport type, the
Smartport type of the interface is set to this static type.
• If the Startup Configuration File specifies a Smartport type that was
dynamically assigned by Auto Smartport:
- If the Auto Smartport Global Operational state, the interface Auto
Smartport state, and the Persistent Status are all Enable, the Smartport
type is set to this dynamic type.
- Else the corresponding anti-macro is applied and the interfaces status is
set to Default.

Macro Failure and the Reset Operation

A Smartport macro might fail if there is a conflict between the existing
configuration of the interface and a Smartport macro.
When a Smartport macro fails, a SYSLOG message containing the following
parameters is sent:
for a listing of the built-in Smartport macros for
11
Type Settings page.
196