Cisco 350XG series Administration Manual page 70

Administration
System Log
STEP 3
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
Click Apply. The Running Configuration file is updated.
Remote Logging Settings
The Remote Log Servers page enables defining remote SYSLOG servers to which
log messages are sent. For each server, you can configure the severity of the
messages that it receives.
To define SYSLOG servers:
Click Administration > System Log > Remote Log Servers.
Enter the following fields:
• IPv4 Source Interface—Select the source interface whose IPv4 address
will be used as the source IPv4 address of SYSLOG messages sent to
SYSLOG servers.
• IPv6 Source Interface—Select the source interface whose IPv6 address
will be used as the source IPv6 address of SYSLOG messages sent to
SYSLOG servers.
If the Auto option is selected, the system takes the source IP address
NOTE
from the IP address defined on the outgoing interface.
Information is described for each previously-configured log server. The fields are
described below in the Add page.
Click Add.
Enter the parameters.
• Server Definition—Select whether to identify the remote log server by IP
address or name.
• IP Version—Select the supported IP format.
• IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The
options are:
- Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80::/10, is not routable,
and can be used for communication only on the local network. Only one
link local address is supported. If a link local address exists on the
interface, this entry replaces the address in the configuration.
5
66