Cisco 350XG series Administration Manual page 250

VLAN Management
VLAN Groups
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
These MAC-based groups can be assigned to specific ports/LAGs. MAC-based
VLAN groups cannot contain overlapping ranges of MAC addresses on the same
port.
Workflow
To define a MAC-based VLAN group:
1. Assign a MAC address to a VLAN group ID (using the
Groups page).
2. For each required interface:
a. Assign the VLAN group to a VLAN (using
page). The interfaces must be in General mode.
b. If the interface does not belong to the VLAN, manually assign it to the VLAN
using the Port to VLAN
MAC-based VLAN Groups
See Table 1 for a description of the availability of this feature.
To assign a MAC address to a VLAN Group:
Click VLAN Management > VLAN Groups > MAC-Based Groups.
Click Add.
Enter the values for the following fields:
• MAC Address—Enter a MAC address to be assigned to a VLAN group.
This MAC address cannot be assigned to any other VLAN group.
NOTE
• Prefix Mask—Enter one of the following:
- Host—Source host of the MAC address
- Length—Prefix of the MAC address
• Group ID—Enter a user-created VLAN group ID number.
Click Apply. The MAC address is assigned to a VLAN group.
MAC-Based Groups to VLAN
See Table 1 for a description of the availability of this feature.
MAC-Based Groups to VLAN
page.
12
MAC-based VLAN
241