Chapter 10: Port Management; Workflow - Cisco 350XG series Administration Manual

Port Management

Workflow

Cisco 350XG & 550XG Series 10G Stackable Managed Switches
This section describes port configuration, link aggregation, and the Green
Ethernet feature.
It covers the following topics:
• Workflow
• Port Settings
• Error Recovery Settings
• Loopback Detection Settings
• Link Aggregation
• UDLD
• Green Ethernet
To configure ports, perform the following actions:
1. Configure port by using the
2. Enable/disable the Link Aggregation Control (LAG) protocol, and configure the
potential member ports to the desired LAGs by using the
page. By default, all LAGs are empty.
3. Configure the Ethernet parameters, such as speed and auto-negotiation for the
LAGs by using the
4. Configure the LACP parameters for the ports that are members or candidates
of a dynamic LAG by using the
5. Configure Green Ethernet and 802.3 Energy Efficient Ethernet by using the
Properties page.
Port Settings
LAG Settings page.
LACP page.
10
page.
LAG Management
159