Defining Trap Settings; Notification Recipients - Cisco SF500-24 Administration Manual

Configuring SNMP

Defining Trap Settings

STEP 4
Defining Trap Settings
STEP 1
STEP 2
STEP 3
STEP 4

Notification Recipients

Cisco 500 Series Stackable Managed Switch Administration Guide
- View Name—Select an SNMP view (a collection of MIB subtrees to
which access is granted).
• Advanced—Select this mode for a selected community.
- Group Name—Select an SNMP group that determines the access rights.
Click Apply. The SNMP Community is defined, and the Running Configuration is
updated.
The Trap Settings page enables configuring whether SNMP notifications are sent
from the switch, and for which cases. The recipients of the SNMP notifications can
be configured in the Notification Recipients SNMPv1,2 page, or the
Recipients SNMPv3
page.
To define trap settings:
Click SNMP > Trap Settings. The
Select Enable for SNMP Notifications to specify that the switch can send SNMP
notifications.
Select Enable for Authentication Notifications to enable SNMP authentication
failure notification.
Click Apply. The SNMP Trap settings are written to the Running Configuration file.
Trap messages are generated to report system events, as defined in RFC 1215.
The system can generate traps defined in the MIB that it supports.
Trap receivers (aka Notification Recipients) are network nodes where the trap
messages are sent by the switch. A list of notification recipients are defined as the
targets of trap messages.
Trap Settings
page is displayed.
22
Notification
418