Stack Management - Cisco 350XG series Administration Manual

Administration: Stack Management

Stack Management

Stack Management
STEP 1
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
Connecting Units
Two units can only be connected in a stack if the stack ports on both ends of the
link are of the same speed. You must check that both ports support the same
speed.
Cables Types
The following describes the cable types supported.
Connector Type
Cisco SFP-H10GB-CU1M – Passive Copper Cable
Cisco SFP-H10GB-CU3M – Passive Copper Cable
Cisco SFP-H10GB-CU5M – Passive Copper Cable
Cisco SFP-10G-SR
Cisco SFP-10G-LRM
Cisco SFP-10G-LR
1G SFP Module MGBSX1
1G SFP Module MGBT1
1G SFP Module MGBLX1
1G SFP Module MGBBX1
100Mbs SFP Module MFELX1
100Mbs SFP Module MFEFX1
100Mbs SFP Module MFEBX1
Other SFPs
To configure the stack:
Click Administration > Stack Management.
The operational status of a standalone device or a stack is displayed in the Stack
Operational Status block.
• Stack Topology—Displays whether the topology of the stack is chain or
ring.
Stack Ports or Network Ports
7
All ports
1G - 10G
1G - 10G
1G - 10G
Not supported
Not supported
Not supported
1G
1G
1G
1G
Not supported
Not supported
Not supported
1G
114