Inserting The Sd Card - Siemens LOGO! CMR2040 Operating Instructions Manual

8. Enter the PIN of your SIM card in WBM in the "WAN", Mobile wireless settings" tab.
Note
Entry of an incorrect PIN
The last entered (incorrect) PIN is saved. This means that when changing the
configuration (except the PIN) or when restarting the CMR, no further PIN entry attempt is
used up.
For this reason, do not change the PIN of the SIM card to the previously stored incorrect
PIN outside the CMR.
9. Click the "Apply" button: the PIN of your SIM card is adopted.
10.Make the appropriate settings, see section Configuration (WBM) (Page 53).
Unlocking the SIM card
If you enter the PIN incorrectly three times, the SIM card will be locked.
Unblock the SIM card as follows:
1. Shut the CMR down to the safe status: "Turning off the CMR" (Page 42).
2. Disconnect the CMR from the power supply.
3. Remove the SIM card and close the compartment.
To remove the SIM card, press the left-hand sunken ejector button with a sharp object.
4. Insert the removed SIM card in a mobile phone.
5. Unblock the SIM card by entering the PUK or the SuperPIN.
You will have received the PUK or SuperPIN from your mobile wireless provider along
with the SIM card.
Result: The SIM card is unblocked and can be used again.
3.4.3

Inserting the SD card

Figure 3-3
You will find the SD cards supported by the CMR in the appendix SD card (Page 161).
LOGO! CMR2020, LOGO! CMR2040
Operating Instructions, 10/2016, C79000-G8976-C356-03
Slot for the micro SD card (yellow rectangle)
Installation, connecting up, commissioning
3.4 Commissioning the device
45