Events - Siemens LOGO! CMR2040 Operating Instructions Manual

Configuration (WBM)
5.13 Monitoring
Change signal / Add new signal
● Name
Symbolic name of the signal
Following this the signal name is used for the event and assignment configuration and
can be used in SMS commands.
● Signal source
"LOGO! BM" for the BM or "LOGO! CMR" for the CMR
● Signal type
(see list above)
Depending on the signal type further drop down lists are displayed:
● Trigger type
● Number
● Address
● Bit
5.13.8

Events

For a selected signal, you configure an event, for example I1 "Changes to 0".
In the upper part of the page, you will see a list with the currently configured events.
A maximum of 32 events can be configured.
Add event / Change event
An input box and two drop-down lists are then available for the configuration:
● Name
Freely selectable symbolic name for the event.
Following this the event name will be used for the assignment configuration.
● Signal name
Select the relevant signal from the drop-down list.
All the signals you have configured along with their symbolic names are available.
● Event
You configure the event. Examples:
The digital input changes from "1" to "0".
The analog flag falls below or exceeds the value you specify this point.
Depending on the selection you have made in "Signal name" and "Event", further buttons will
become available with which you can complete your event.
116
LOGO! CMR2020,
Operating Instructions, 10/2016, C79000-G8976-C356-03
LOGO! CMR2040