Siemens LOGO! CMR2040 Operating Instructions Manual page 66

Configuration (WBM)
5.4 Establishing a connection to the CMR
Do not use a proxy server
Follow the steps outlined below depending on the operating system:
1. Select the "Tools" > "Internet Options" menu command.
2. Select the "Connections" tab.
3. Click the "LAN settings" button.
The "Local Area Network Settings" dialog opens.
4. Under the "Proxy server" entry, disable the "Use a proxy server for your LAN" check box.
Disable other LAN connections
If other LAN connections are active on the PC, disable these LAN connections while you are
setting the configuration.
Follow the steps below if working with Windows 7:
1. In the Start menu, select the command "Start" > "Control Panel" > "Network and Internet"
> "Network and Sharing Center"
2. In "View your active networks" you will see the current LAN connections.
3. In "Access type: Connections", left-click on the relevant connection names.
The dialog box associated with the connection opens.
4. Click the "Disconnect" button.
The dialog closes, you have deactivated the required LAN connection.
Changing the interface of the CMR after configuration
It is possible that after configuring the CMR, you may need to adapt the LAN interface of the
CMR for the connected computer or adapt the local network.
Follow the steps outlined below:
1. Select the page "LAN > Configuration" in the navigation panel.
2. Make the address changes there.
3. Click the "Apply" button.
Result: Your settings are then adopted by the CMR.
66
LOGO! CMR2020,
Operating Instructions, 10/2016, C79000-G8976-C356-03
LOGO! CMR2040