Insert The Sim Card And Enter The Pin - Siemens LOGO! CMR2040 Operating Instructions Manual

Installation, connecting up, commissioning
3.4 Commissioning the device
3.4.2

Insert the SIM card and enter the PIN

NOTICE
Disconnecting the CMR from the power supply before inserting or removing the SIM card
Do not remove the SIM card during operation.
1. Shut the device down to a safe status.
2. Disconnect the CMR from the power supply before inserting or removing the SIM card.
Figure 3-2
The compartment for the SIM card is located on the front of the CMR.
Status of the CMR before inserting/removing the SIM card
The CMR is brand new or has been reset to the factory settings:
● A SIM card is inserted for the first time.
The CMR is or has already been in operation:
● Only a different SIM card is inserted.
Inserting/removing the SIM card
1. In the WBM in "WAN", "Mobile wireless settings" tab, deselect the "Activate mobile
wireless interface" check box:
The mobile wireless interface is turned off.
2. Shut the CMR down to the safe status: "Turning off the CMR" (Page 42).
3. Disconnect the CMR from the power supply.
4. Only if the CMR is or was in operation: Remove the SIM card and close the compartment.
To remove the SIM card, press the left-hand sunken ejector button with a sharp object.
5. Insert the SIM card into the compartment until you can feel the card lock in place.
6. Restart the CMR by connecting up the power supply.
7. In the WBM, in "WAN", "Mobile wireless settings" tab, select the "Activate mobile wireless
interface" check box:
The mobile wireless interface is once again ready for operation.
44
Compartment for the SIM card (red rectangle)
LOGO! CMR2020,
Operating Instructions, 10/2016, C79000-G8976-C356-03
LOGO! CMR2040