Siemens LOGO! CMR2040 Operating Instructions Manual page 147

Applied standards:
● EN 60079-0
Hazardous areas - Part 0: Equipment - General requirements
● EN 60079-15
Explosive atmospheres - Part 15: Equipment protection by type of protection 'n'
The current versions of the standards can be seen in the EC Declaration of Conformity, see
above.
ATEX approval: II 3 G Ex nA II T4 Gc
Test number: KEMA 07 ATEX 0145 X
Over and above this, the following conditions must be met for the safe deployment of the
product according to the section Notices on use in hazardous areas according to ATEX
(Page 37).
You should also note the information in the document "Use of subassemblies/modules in a
Zone 2 Hazardous Area" that you will find on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
Radio equipment directive
The CM meets the requirements of the EC directive 2014/53/EU (Radio equipment)
according to the requirements of article 3 (1) a, 3 (1) b and 3 (2).
Article 3 (1) a - Health and Safety
Harmonized standards:
● EN 60950-1+A1+A2+A11+A12
Information technology equipment - Safety - Part 1: General requirements
● EN 62311
Assessment of electronic and electrical equipment related to human exposure restrictions
for electromagnetic fields (0 Hz ... 300 GHz)
Art. 3 (1) b - EMC
Harmonized standards:
● ETSI EN 301 489-1
Electromagnetic compatibility and radio spectrum matters (ERM) - Electromagnetic
compatibility for radio equipment and services - Part 1: Common technical requirements
● ETSI EN 301 489-3
Electromagnetic compatibility and radio spectrum matters (ERM) - Electromagnetic
compatibility (EMC) for radio equipment and services - Part 3 : Specific conditions for
wireless devices with a low range (SRD) for use on frequencies between 9 kHz and 246
GHz
LOGO! CMR2020, LOGO! CMR2040
Operating Instructions, 10/2016, C79000-G8976-C356-03
Approvals
147