Table of Contents
Advertisement
If, for example, a PI-SMS message requested using SMS was sent incompletely, repeat your
request SMS message.
SMS error messages
You will find a list of all possible error messages in SMS error messages (Page 165).
B.2
SMS error messages
Message
OK
Invalid Command
Invalid Parameter
No Success
Try Again
No connection to LOGO! BM
No GPS Signal
Not supported by LOGO! BM
B.3
Syntax of all SMS commands
Syntax of the SMS commands and possible responses
What information would I like to have?
Read diagnostics data from the CMR
Read GPS position from the CMR
Read process image (PI)
Read status of the BM
Read current value
LOGO! CMR2020,
LOGO! CMR2040
Operating Instructions, 10/2016, C79000-G8976-C356-03
Possible causes
The SMS command was executed successfully.
SMS keyword could not be recognized.
Check the uppercase/lower case characters and syntax.
Transfer parameter not correct; password not correct.
Values could not be set or read.
The CMR is currently being reconfigured. The request can-
not be processed.
LOGO! BM not activated or wrong IP address set.
•
Cable between LOGO! BM and LOGO! CMR discon-
•
nected
GPS not configured
•
GPS signal cannot be received because there is no line
•
of sight to the GPS satellite.
The setting of bits in the VM of the LOGO! BM is not sup-
ported by this device version (previous firmware version)
Example
DIAG?
GPSPOSITION?
MONITOR?
STATUS?
LOGO?VM125,WORD
Additional information on SMS
B.2 SMS error messages
165
Hide quick links:
Advertisement
Table of Contents
