Siemens LOGO! CMR2040 Operating Instructions Manual page 65

Entering the user name and password
You will be prompted to enter the user name and the password. The factory settings are as
follows:
User data
User name
Password
After you log in the first time, you will be prompted to change your password. Keep to the
basic rules for a secure password (refer to the notes in the WBM)
Note
Changing standard user data
For security reasons, it is recommended that you create another user after the first login.
You will find the description in the section Users / groups (Page 104).
Note
Loss of changed standard user data
Note changed or newly assigned user names and passwords.
If you change user data of the standard user, lose the changed user data and have not
created a second user, you no longer have access to the WBM of the CMR. In this case, you
can only access the WBM of the CMR after resetting to the factory settings. When you reset
the configuration data is lost.
The start page is displayed
After entering the user name and password, the start page of the CMR opens in the Web
browser. The start page provides an overview of the operating status of the device.
The start page is not displayed
If, after several attempts, the browser still reports that the page cannot be displayed, try the
following:
Checking the hardware connection
1. Open the DOS command prompt by selecting the menu command "Start" > "Programs" >
"Accessories" > "Command Prompt".
Result: The "Command Prompt" window appears.
2. Enter the command "ping 192.168.0.3".
When operating correctly, you will receive four replies within a few seconds.
If you do not receive four feedback messages within a few seconds, check whether the
network cable, the connectors and the network adapter are correctly connected.
LOGO! CMR2020, LOGO! CMR2040
Operating Instructions, 10/2016, C79000-G8976-C356-03
5.4 Establishing a connection to the CMR
Default values set in the factory
admin
admin
Configuration (WBM)
65