Connecting Method D - Connection Of Powered Extension Units/Blocks - Mitsubishi FX3U SERIES User Manual

FX Series Programmable Controllers
3U
User's Manual - Hardware Edition
8.7.5

Connecting method D - connection of powered extension units/blocks

This subsection explains the procedures for connecting FX
blocks or FX
0N
1
Remove the top cover (B in the right figure) of
the existing unit/block (left side) (A in the right
figure).
• When connecting FX
extension block connector cover.
• When connecting FX
remove the top cover of FX
2
Connect the extension cable (C in the above figure) of the block to be con-
nected (right side) to the existing unit/block (A in the above figure).
• When FX
2N
FX -1PSU-5V units are connected, connect the unit to be added (right side) and the existing unit (left
3U
side) with the supplied extension cable.
3
Fit the top cover (B in the above figure) (except when connecting FX
or FX -20GM).
2N
144
/FX /FX Series special function units/blocks.
2N 3U
-10GM or FX
2N 2N
-1RM(-E)-SET or FX
2N
-1RM(-E)-SET or FX
2N
Series input/output powered extension units, FX
8.7 Connecting Methods for Main Unit and Extension Devices
Series input/output powered extension units/
2N
-20GM, remove the PLC
-1PSU-5V,
3U
-1PSU-5V.
3U
-10GM, FX
2N
8 Installation In Enclosure
B
1
C
A
-20GM, FX -1RM(-E)-SET or
2N 2N
-10GM
2N
3