Flex State Parameters - GE b30 Instruction Manual
Bus differential system
Hide thumbs
Also See for b30:
- Instruction manual (633 pages) ,
- Communications manual (532 pages) ,
- Technical reference manual (252 pages)
Table of Contents
Advertisement
PRODUCT SETUP
5
User-programmable pushbuttons require a type HP or HQ faceplate. If an HP or HQ type faceplate was ordered
separately, the relay order code must be changed to indicate the correct faceplate option. This can be done in the
EnerVista software with the Maintenance > Enable Pushbutton command.
5.3.15 Flex state parameters
SETTINGS PRODUCT SETUP FLEX STATE PARAMETERS
FLEX STATE
PARAMETERS
This feature provides a mechanism where any of 256 selected FlexLogic operand states can be used for efficient
monitoring. The feature allows user-customized access to the FlexLogic operand states in the relay. The state bits are
packed so that 16 states are readable in a single Modbus register. The state bits can be configured so that all states of
interest are available in a minimum number of Modbus registers.
5-114
Figure 5-49: User-programmable pushbutton logic (Sheet 2 of 2)
PARAMETER 1:
Off
PARAMETER 256:
Off
CHAPTER 5: SETTINGS
Range: FlexLogic operand
Range: FlexLogic operand
B30 BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL
Advertisement
Table of Contents
