Enter Assigned Bis Address In The Dtm - Pepperl+Fuchs HD2-GTR-4PA Manual

PROFIBUS Commissioning
8. Drag the HD2-GTR-4PA into the project window into the PRO-
FIdtm DPV1 node. The window Add station address will appear.
•
9. Enter the station address (BIS address of the Gateway) and con-
firm with OK.
Your project tree should now look like this:
•


Enter assigned BIS address in the DTM

To enter the BIS address (which has been assigned on the Gateway-
motherboard) into the DTM, proceed as follows:
1. Rightclick on PROFIdtm DPV1 in the project tree and choose
Additional Functions/Edit DTM Station Addresses.
2. Enter the BIS address set on the Gateway Motherboard and con-
firm with Apply:
•
In rare cases, the FDT application may not immediately display the
address change in the project window even though the change has been
made.
In that case, save the project once to update the display.
Note
Subject to reasonable modifications due to technical advances.
38
Pepperl+Fuchs Group • Tel.: Germany +49 621 776-0 • USA +1 330 4253555 • Singapore +65 67799091 • Internet http://www.pepperl-fuchs.com
P R O F I B U S P
O W E R
H S
U B E G M E N T
Copyright Pepperl+Fuchs, Printed in Germany
C
O U P L E R