Installation And Commissioning; Mounting And Dismounting; Mounting Motherboards On A Din Rail; Mounting Of Hd2-* Modules On The Motherboard - Pepperl+Fuchs HD2-GTR-4PA Manual

Installation and Commissioning

3 Installation and Commissioning
3.1

Mounting and Dismounting



Mounting Motherboards on a DIN rail

To mount a motherboard, proceed as follows:
1. Place the motherboard on the DIN rail.
2. Tighten the fastening screw in the middle of the motherboard to at-
tach the motherboard to the DIN rail.
The motherboard is mounted. Dismounting is performed in the reverse
order.
•


Mounting of HD2-* modules on the Motherboard

To install a new module on the motherboard, proceed as follows.
1. Carefully center the polarisation holes and mate the two con-
nectors, then gently press down the module.
2. Push down the red Quick Lok bars on each side of the module to
fix it to the panel (no tools required).
The new module is installed.
•
Subject to reasonable modifications due to technical advances.
22
Pepperl+Fuchs Group • Tel.: Germany +49 621 776-0 • USA +1 330 4253555 • Singapore +65 67799091 • Internet http://www.pepperl-fuchs.com
P R O F I B U S P
O W E R
H S
U B E G M E N T
Copyright Pepperl+Fuchs, Printed in Germany
C
O U P L E R